How do I program my Entone URC4 remote to my TV?

How do I program my Entone URC4 remote?

1. Turn on your TV or your A/V device.

2. On the remote control, press a device mode key (i.e. “TV” “AUX”) and hold for 5 seconds. The device mode key will light up.

 

NOTE : Use the “AUX” mode key for a VCR, DVD player, cable box, satellite receiver or audio device.

 

3. Press the “POWER” key once.

4. Aim the remote control at the device. Press either the “CH UP” key or “CH DOWN” key to start device auto-scan:

a. Press the “CH UP” key to start searching from the lowest device code to the highest at approximate 5 second intervals; OR b. Press the “CH DOWN” key to start searching from the highest device code to the lowest at approximately 5 second intervals. The “TV” or “AUX ” mode key will be on and blink every 5 seconds while in the device scan mode.

5. If the device turns off, a working code has been found. Press “OK” once to lock in the code. The selected mode key will blink twice.

6. If all code sets for that device are exhausted in the search and the “OK” is not pressed, the selected device key will blink rapidly 7 times and the search mode will be terminated.

 

NOTE : During the auto-scan, you can press “UP” arrow or “DOWN” arrow to advance to the next device code immediately without waiting for 5 seconds. You can also use “UP” arrow or “DOWN” arrow to change the direction of the search. While in programming mode, if no key is pressed within 30 seconds, the device mode key backlight will blink rapidly 7 times and then stop - indicating an error.

 

Entone URC Remote

TV